Поз.
Артикул
Описание
10
FUEL TANK
10
FUEL TANK
20
BREATHER PIPE REFUELLING VENT LINE TO FUEL TANK
20
VENTILATION LINE REFUELLING VENT LINE TO FUEL TANK, A 12038220070424
40
FUEL DELIVERY MODULE FUEL
40
DELIVERY UNIT FUEL
55
SUCTION JET PUMP , Replaced By: A2114704094, +001A2114400507
55
WIRING HARNESS PRESSURE SENDING UNIT, TANK
55
DELIVERY UNIT WITH FLUID LEVEL SENSOR
55
DELIVERY UNIT WITH FLUID LEVEL SENSOR
57
PRESSURE SENSOR
60
TENSIONING STRAP TANK ATTACHMENT, A 10457620070111
60
TENSIONING STRAP TANK ATTACHMENT, A 10457520070111
70
RUBBER SLEEVE , A 74703120041029 E 01999920070101
80
BUSHING
100
NUT MAINTENANCE OPENING
110
SEAL RING
110
SEALING RING MAINTENANCE OPENING, Replaced By: A2114710579
120
BRACKET VENT LINE TO LONGITUDINAL MEMBER
130
BRACKET VENT LINE TO FILLER NECK
140
FILLER NECK FUEL TANK, A 09500720060930 A 14513420080530
140
FILLER NECK FUEL TANK, A 14513520080530
140
FILLER NECK FUEL TANK
140
FILLER NECK FUEL TANK, A 09500620060930
140
FILLER NECK FUEL TANK
151
HOSE FILLER NECK TO CHARCOAL FILTER
151
HOSE FILLER NECK TO CHARCOAL FILTER
155
HOSE FROM FEED LINE TO FILTER 240 MM
160
HOSE CLAMP HOSE ATTACHMENT
161
LOOM TIE HOSE TO FILLER NECK
190
LINE SERVICE VENT LINE BETWEEN FILLER NECK AND TANK, RIGHT
190
LINE SERVICE VENTILATION LINE BETWEEN FILLER NECK AND TANK, LEFT
192
HOSE FROM FEED LINE TO FILTER 240 MM
192
HOSE FUEL LINE TO TANK 13.5 X 7.5 MM, ORDER BY THE METER
195
VENT LINE VENT LINE BETWEEN FILLER NECK AND TANK
195
LINE VENT LINE BETWEEN FILLER NECK AND TANK
196
GROMMET TO FUEL TANK
200
HOSE FILLER PIPE TO FUEL TANK, Replaced By: A2114768926
200
HOSE FILLER PIPE TO FUEL TANK
201
HOSE FILLER PIPE TO FUEL TANK, A 04202320050726, Replaced By: A2114766826
201
HOSE FILLER PIPE TO FUEL TANK, FIRST EXHAUST STOCK OF OLD PARTS UP TO IDENT NO. A 04202320050726, Replaced By: A2114769026
201
HOSE FILLER PIPE TO FUEL TANK
205
CLAMP ADVANCE ENGINE 27-30 MM
210
HOSE CLAMP HOSE ATTACHMENT
215
HOSE CLAMP HOSE FASTENING
220
CLAMP SUCTION LINE TO OIL PUMP 40-60X13 MM
230
CLAMP SUCTION LINE TO OIL PUMP 40-60X13 MM
240
BOLT ATTACHMENT STRAP M8X18
250
HEXAGON NUT. NUT SPARE WHEEL CARRIER TO REAR END DOOR
260
WASHER BRACKET TO FENDER,K 104588
270
RUBBER SLEEVE
280
BOLTM6X18
290
FUEL FILLER CAP , J 75730520090630 TO BE ADAPTED DURING ASSEMBLY
290
FILLER CAP TANK FILLER NECK, E 02000020070101802 A 17199120010928802
290
FILLER CAP
300
SEAL RING FILLER CAP
300
SEAL RING FILLER CAP TO FILLER NECK
305
EXPANSION RIVET. RIVET
310
GROMMET TANK FILLER NECK
330
HOSE FROM FEED LINE TO FILTER 240 MM
350
BRACKET ADAPTER:
360
BRACKET ADAPTER:
700
BLIND PLUG. GASKET WITHE ELB 4
700
PLUG PLUG CONNECTION FOR FUEL PUMP WIRING HARNESS 5-PIN SLK2.8,X36/3, ATTN.: FROM IDENT. A 237174, F 177685, R 028782 TO IDENT. A 30 4093, F 232212, R 045744, MIXED INSTALLATION POSSIBLE NOTE CONTACTING, NOT VALID FOR 4-PIN CONNECTOR
700
GASKETTO 001 545 24 81, A 218853 ALSO INSTALLED ON A 103237 - A 218851 WITH CODE 030 F 190066 ALSO INSTALLED ON F 159752 - F 190064 WITH CODE 030 EXCEPT FOR A 219847
710
REP.SET CONTACT0.75 MM2 SLK2.8, CONNECTORS MUST ALSO BE ORDERED IN ACC. WITH THE TOTAL CABLE C ROSS-SECTION TO BE CONNECTED. SEE WIS FOR REPAIR INSTRUCTIONS.SOLDER CONNECTOR SLEEVES:TOTAL WIRE CROSS-SECTION: A 001 546 99 41GREEN0.7 -2.4 MM2 A 002 546 00 41RED2.0 -4.0 MM2 A 002 546 01 41BLUE 3.5 -8.0 MM2 A 002 546 11 41YELLOW 7.5 - 12.0 MM2 BUTT JOINT: A 002 546 13 41 0.5 MM2 A 002 546 14 41 0.8 MM2 A 002 546 15 41 1.3 MM2 A 002 546 16 41 2.0 MM2
720
PIN BUSHING HOUSING 3-POLE
730
GASKET YELLOW 0.2-0.5MM2,126373
730
CONTACT SPRING0.35-0.5 MM2 MINI MIC